The KST CM712 is a Clubman-category servo manufactured by KST Meizhou Company Limited.
The KST CM712 is a servo from KST Meizhou Company Limited.
The CM712 belongs to the Clubman servo category.
| Specification | Value & conditions |
|---|---|
| Manufacturer | KST MEIZHOU COMPANY LIMITED |
| Model | CM712 |
| Product category | Clubman servo |
The MAD FLUXER PRO 18x5.9 in Shine Prop is a two-piece carbon fiber drone propeller set with a shine finish and D6-D12(M3*2) mounting holes. Its pitch and airfoil design target responsive power delivery and efficient endurance flight.
The HOBBYWING XRotor FPV G2 45A 4in1 ESC is an integrated brushless motor controller intended for FPV racing builds. It combines four ESC channels, AM32 firmware and flight-controller connection options in a compact board. Procurement planning should account for solder-tab motor outputs and conflicting BEC descriptions.
The T-MOTOR AT195A is a heavy-lift fixed-wing electronic speed controller supporting 6–14S LiPo batteries and 195A continuous current. Its configuration combines optimized motor-control firmware, an aluminum heat sink, built-in anti-spark protection, and low-voltage, thermal and signal-loss protection.
The Scorpion HKIII-5020 shaft kit (6mm 44mm) is a helicopter motor shaft accessory in the HKIII-50 Series range. Supplied as a component kit, it has a stated weight of 54g including packaging and carries the product description designation FSR-E.
The EMAX ECO II 4720 Brushless Motor serves large FPV aircraft and heavy-lift platforms using 15-inch propellers. Its 290KV configuration uses 12S batteries, while 380KV supports 6-8S. The motor combines a 55.1 mm diameter, 71 mm length, four-hole M4 mounting, silicone leads and supplied mounting hardware.
The GEPRC TAKER F722 45A 32Bit AIO is a compact UAV flight-controller and ESC assembly supplied with wiring, a capacitor and damping hardware. It combines an STM32F722 processor, SPI IMU, barometer, five full UARTs and a dedicated HD video transmitter connection in a 9.2g board supporting 2–6S LiPo input.
The MAD V105 IPE V2.0(30p) EVTOL Drone Motor is a 170KV propulsion component weighing 999g. Designed for payloads of 10-13kg per rotor with a 30″ carbon propeller, it delivers maximum thrust up to 30.4kg per rotor and incorporates centrifugal heat dissipation, IP35 protection and defined mounting interfaces.
The TYI F405 V3 50A BLS Flight Controller Stack is a control-electronics product for RC FPV drones. It combines an F4 flight-controller designation with a 4-in-1 50A ESC configuration, retaining F405 V3 and BLS as identifiers in the stack’s model name.
The HOBBYWING MFC 63x24 is a folding carbon-fiber propeller for large-drone propulsion. Its published configuration combines composite blades with an aluminum-alloy adapter, with total weight including the adapter. Reversible mounting supports forward and reverse installations, while motor selection, matched-pair use and operating limits define key procurement checks.
The Maytech Brushless 5055 MTO5055-G Ghost Series is a sensorless outrunner motor for RC planes and helicopters. It has a 50x42.5mm motor size, 6mm shaft, 290 g net weight and 6-12S LiPo input. Its KV designations differ, and usual KV tolerance is about 5%-10%.