ChinaDrone.Request a quote ↗
COMPONENT

RadioLink TS100 v2.0

By RadioLink Electronic Limited ↗

RadioLink Electronic Limited’s RadioLink TS100 v2.0 is an M10N GPS module for flight-controller integration, combining satellite positioning with an electronic compass. It incorporates ceramic antennas, two-stage filtering and a low-noise amplifier, supports simultaneous operation across four satellite systems, and is supplied as one module with a packing bag.

Request a quote ↗
RadioLink TS100 v2.0 GPS module with black square housing, attached cable and white connector
RadioLink TS100 v2.0 GPS module with black square housing, attached cable and white connector
ProductRadioLink TS100 v2.0 M10N GPS module
Out-of-band interference filteringTwo-stage filtering with 78db attenuation for out-of-band interference
In-band interference suppressionHigh-linearity LNA with an in-band input 1dB compression point of -3dBm
Reception frequencies1561±1MHz, 1575±1MHz, 1602~1610MHz
Baud rate38.4K
Supply voltage5±5%VDC

Product overview

The RadioLink TS100 v2.0 combines a Ublox M10050 GPS decoder, ceramic chip antennas and an IST8310 electronic compass with an I2C interface. Its reception architecture pairs a low-loss circuit ahead of the low-noise amplifier with two-stage Murata surface acoustic wave filtering. The filter provides 78db attenuation against out-of-band interference, while the amplifier has an in-band input 1dB compression point of -3dBm. Reception covers 1561±1MHz, 1575±1MHz and 1602~1610MHz, with simultaneous operation across BD1, GPS/L1, Galileo/E1 and GLONASS/G1.

Integration uses RX, TX, VCC, GND, SCL and SDA connections, with a 5±5%VDC supply, 50-100mA current and 38.4K baud rate. The module automatically adapts its protocol when connected to a flight controller and returns to NMEA after disconnection. Positioning accuracy is specified as 50 centimeters; acquisition of 20 satellites in 6 seconds applies at open ground. Super Simple Modes require use with RadioLink Mini Pix. The supplied configuration consists of one TS100 v2.0 (M10N) module and one packing bag.

Specifications

SpecificationValue & conditions
ProductRadioLink TS100 v2.0 M10N GPS module
Out-of-band interference filteringTwo-stage filtering with 78db attenuation for out-of-band interference
In-band interference suppressionHigh-linearity LNA with an in-band input 1dB compression point of -3dBm
Reception frequencies1561±1MHz, 1575±1MHz, 1602~1610MHz
Baud rate38.4K
Supply voltage5±5%VDC
Current50-100mA
GPS decoder chipUblox M10050
Antenna2.5dbI high-gain, high-selectivity ceramic chip antennas
Filter hardwareTwo-stage Murata surface acoustic wave filter
RF circuit architectureLow-loss pre-LNA circuit matched to the ceramic chip antennas
Electronic compassBuilt-in IST8310 electronic compass with I2C port
Energy-storage componentSupercapacitors
Positioning accuracy50 centimeters
Satellite acquisition20 satellites in 6 secondsAt open ground.
Station keepingStation-keeping capabilityAt the valley bottom.
Satellite systemsBD1, GPS/L1, Galileo/E1 and GLONASS/G1; simultaneous four-system operation
Default protocolNMEAWhen disconnected from the flight controller.
Protocol adaptationAutomatic flight-controller recognition and protocol switchingWhen connected to a flight controller.
Flight-mode integrationSuper Simple ModesWith the RadioLink Mini Pix flight controller.
Module-side wire signalsRX, TX, VCC, GND, SCL and SDA
Packing list1 × TS100 v2.0 (M10N); 1 × packing bagSupplied configuration.
SOURCE WITH CHINADRONE

Request a quote for RadioLink TS100 v2.0

Send your application, destination country and expected quantity to the ChinaDrone team. We can discuss product selection, configuration and sourcing from China.

Submit your procurement requirements ↗

No account needed. A model number is optional. Your enquiry is handled by ChinaDrone.

KEEP EXPLORING

Similar products

Browse all products ↗
CUAV C-RTK 3 X20P GNSS module in a black housing with mounting tabs.
Flight control & navigation

CUAV C-RTK 3 X20P GNSS Module

By CUAV

The CUAV C-RTK 3 X20P GNSS Module combines a u-blox X20 receiver, STM32H5 processor and RM3100 compass for precision navigation in unmanned and industrial systems. It supports RTK/PPP-RTK positioning and multiple host communication methods. Rover and base station options each include an antenna; the product is an integration component, not a flight platform or airframe kit.

Flight control & navigation

Allspark 2-Orin NX

By AMOVLAB

The AMOVLAB Allspark 2-Orin NX is an onboard computer. Its role is airborne computing, with Allspark 2-Orin NX identifying the model and AMOVLAB identifying the manufacturer. The product is classified as an aircraft computing component.

Flight control & navigation

BW-AH200

By BWSENSING

The BWSENSING BW-AH200 is a compact, low-cost attitude and heading reference system for integration into UAVs and other motion-control equipment. It combines specified gyroscope and accelerometer measurements with selectable serial outputs, 0.5° roll and pitch accuracy, and 0.8° heading accuracy in a 60 × 59 × 29 mm package.