ChinaDrone.Request a quote ↗
COMPONENT

TX-AG011 GPS Beidou Dual Mode Positioning Module

By Dongguan Tengxiang Electronics Co., Ltd ↗

The Tengxiang TX-AG011 GPS Beidou Dual Mode Positioning Module is an embedded antenna module for GPS and Beidou BDS reception, including use in drone positioning systems. Its compact configuration incorporates RG113 cable and a U.FL female connector, with specified electrical characteristics and separate operating and storage temperature limits.

Tengxiang TX-AG011 GPS Beidou dual-mode positioning module with cable and connector
Tengxiang TX-AG011 GPS Beidou dual-mode positioning module with cable and connector
Frequency1575.42MHz
V.S.W.RAt most 2.0
Antenna gain22 dBi
PolarizationLinear
Impedance50 Ohm
Radiator materialGPS module

Product overview

The Tengxiang TX-AG011 GPS Beidou Dual Mode Positioning Module combines reception from GPS and Beidou BDS in an embedded positioning component. Its purpose is to provide location data for equipment including drone positioning systems, vehicle navigation equipment, IoT trackers, wearables and industrial monitoring terminals. The dual-system design targets positioning continuity in complex urban locations and indoor areas with marginal satellite signals. Compact construction and low power consumption support integration into intelligent devices; the product is a positioning module rather than a flight platform or airframe kit.

The specified physical configuration uses an RG113 cable and a U.FL female connector, with rubber listed for the plastic material and a GPS module listed as the radiator material. Electrical characteristics comprise a 1575.42MHz frequency, linear polarization, 50 Ohm impedance, 22 dBi antenna gain and V.S.W.R of at most 2.0. These define the antenna interface for integration planning. The environmental limits distinguish operation at –20 to +60 °C from storage at –40 to +80 °C, making the narrower operating range relevant when selecting an installation environment.

Specifications

SpecificationValue & conditions
Frequency1575.42MHz
V.S.W.RAt most 2.0
Antenna gain22 dBi
PolarizationLinear
Impedance50 Ohm
Radiator materialGPS module
Plastic materialRubber
Cable typeRG113
Connector typeU.FL female connector
Operating temperature range– 20 ˚C ~ + 60 ˚COperating temperature
Storage temperature range– 40 ˚C ~ + 80 ˚CStorage temperature
Positioning architectureDual-mode satellite positioning antenna module integrating GPS and Beidou BDS reception
Integration characteristicsCompact structure and low power consumption for embedding in intelligent devices
Intended applicationsIoT positioning trackers, wearable devices, vehicle navigation equipment, drone positioning systems and industrial intelligent monitoring terminals

Ask for the TX-AG011 GPS Beidou Dual Mode Positioning Module price ↑

KEEP EXPLORING

Similar products

Browse all products ↗
CUAV V5+ flight controller with silver housing and black connector base.
Flight control & navigation

CUAV V5+ flight controller

By CUAV

The CUAV V5+ flight controller provides power, actuator, receiver, GPS and telemetry connections for vehicle integration. Its documented kit includes a power module, safety switch, SBUS cable and factory-installed SD card. Procurement must account for mounting orientation, peripheral selection and wiring requirements.

Flight control & navigation

BeeRotor F7 BetaFlight Flight Controller with BFOSD

By RCTimer

The RCTimer BeeRotor F7 BetaFlight Flight Controller with BFOSD is a compact UAV control board with an STM32F722 processor, integrated motion and pressure sensors, onboard storage and OSD. Its 37x37mm footprint accommodates multiple serial and ESC interfaces, regulated power outputs, and a dedicated connector for an Ares ESC and DJI FPV Air Unit.

HAKRC 40AminiF7 flight controller and ESC stack with purple mounting grommets
Flight control & navigation

HAKRC 40AminiF7 Stack

HAKRC

Shenzhen Haike Technology Co., Ltd.’s HAKRC 40AminiF7 Stack is a compact UAV electronics assembly pairing an F722 flight controller with a BLHeli-32 four-in-one ESC. It offers 20*20mm mounting, onboard sensing and recording, receiver connections and DJI FPV integration, with separate controller and ESC voltage specifications.