| Product type and functions | F10AP general-purpose UAV flight controller supporting fixed-wing and multirotor platforms, with CAN bus architecture, external positioning and heading modules and motor/servo controllers, integrated navigation, flight control, mission management, and telemetry and control communications. |
|---|
| Control algorithms and architecture | Robust attitude control; total-energy airspeed and altitude control; proprietary extended Kalman filter navigation combining IMU, GNSS, barometer and magnetometer data; support for electric and fuel-powered UAVs, including fixed-wing aircraft and helicopters; CAN 2.0B connections for external sensors, servos and payload equipment; hard real-time operating system and modular software for customization; hardware-in-the-loop flight simulation through serial data exchange. |
|---|
| Sensors and flight functions | Built-in IMU and barometer; data fusion with external GNSS receiver and magnetic compass. Outputs attitude, heading, angular rate, position, velocity and acceleration. Supports altitude, airspeed, position and attitude control for fixed-wing, helicopter and multirotor UAVs; helicopter constant-RPM control; one-touch takeoff and landing; one-touch go-around during fixed-wing runway landing; stationary and moving target following; startup self-test, health monitoring and alerts; engine control, RPM acquisition, temperature-sensor connection and online flight-data recording. |
|---|
| Flight modes | Remote control directly operates control surfaces. Point mode flies to and circles a designated point; waypoint mode follows a preset route; loiter maintains altitude around a center point; return mode returns to the takeoff point and circles along the takeoff/landing circuit. Takeoff mode rolls along the preset runway, climbs at the preset airspeed, then circles along the circuit after reaching the preset altitude and airspeed. Landing mode approaches, maintains descent, touches down at the preset point and decelerates to a stop; a go-around command returns the aircraft to circling along the circuit. Follow mode tracks target coordinates and circles the target.Automatic takeoff uses preset runway information, airspeed and altitude. Automatic landing uses a preset touchdown point. |
|---|
| Automatic-return protections | Automatic return for remote-control signal interruption, ground-station communication interruption and geofence exceedance.Remote-control or ground-station communication interruption must exceed the preset duration; geofence return activates beyond the preset flight altitude or radius. Each protection can be disabled. |
|---|
| Processor | Clock frequency: 168MHz; processing speed: 225 DMIPS. |
|---|
| Serial ports | RS232 ports: 2; RS422 ports: 2. |
|---|
| RPM acquisition and high-level output | RPM acquisition: 1 channel; high-level I/O output: 1 channel. |
|---|
| Low-level output and SBUS input | Low-level I/O output: 1 channel; SBUS input: 1 channel. |
|---|
| CAN and flight recording | CAN: 2 channels; flight-recording capacity: 32GB. |
|---|
| Navigation output and attitude accuracy | Navigation output frequency: 50Hz; navigation attitude accuracy: 0.5°. |
|---|
| Heading and horizontal position accuracy | Heading accuracy: 2°; horizontal position accuracy: 2.5m cep.Horizontal position accuracy uses single-point positioning. |
|---|
| Navigation velocity accuracy | 0.1m/s. |
|---|
| Gyroscope range and sensitivity | Dynamic range: ±500°/s; sensitivity: 0.015°/s/LSB. |
|---|
| Gyroscope alignment and nonlinearity | Orthogonal alignment error: ±2%; nonlinearity: 0.1%. |
|---|
| Gyroscope noise and mechanical frequency | Noise spectral density: 0.006°/s/√Hz; mechanical frequency: 27kHz. |
|---|
| Accelerometer range and sensitivity | Dynamic range: ±8g; sensitivity: 2.441× 10−4g/LSB. |
|---|
| Accelerometer alignment and nonlinearity | Orthogonal alignment error: 2%; nonlinearity: 0.5%. |
|---|
| Accelerometer noise spectral density | 0.150mg/√Hz rms. |
|---|
| Accelerometer startup and calibration | Startup time: 35ms; calibration temperature range: −40~ +85℃. |
|---|
| Accelerometer shock resistance | 10000g. |
|---|
| Pressure measurement range and accuracy | Range: 10~1200mbar; accuracy: -1.5~+1.5mbar.Pressure accuracy at 25℃ and 750mbar. |
|---|
| Pressure output and resolution | 24-bit digital output; resolution: 12μbar. |
|---|
| Control update frequency and position accuracy | Control update frequency: 100Hz; position control accuracy: ≤0.5m. |
|---|
| Attitude and speed control accuracy | Attitude control accuracy: ≤1°; speed control accuracy: ≤0.2m/s. |
|---|
| Operating and storage temperatures | Operating temperature: -40℃~+60℃; storage temperature: -40℃~+75℃. |
|---|
| Relative humidity | ≤95%.At 25℃. |
|---|