ChinaDroneRequest a quote →

EMAX Nighthawk-X4

The EMAX Nighthawk-X4 is a speed-focused pure X frame with 170mm motor spacing, carbon fiber plates and an integrated power distribution board. It combines regulated power outputs, programmable RGB lighting and an adjustable HD camera mount, with a frame weight of 85g including all hardware.

EMAXDrone frame

Get a free quote

Product overview

The EMAX Nighthawk-X4 uses a pure X layout with equidistant motor positions and centrally arranged components for speed-focused builds. Its 170mm motor-to-motor spacing is paired with 3mm arms available in 4" length, plus 1.5mm carbon fiber top and bottom plates. The 1.5mm power distribution board forms the upper half of the main structural frame, reducing the need for another carbon component. Frame weight is 85g including all hardware, and interchangeable arms allow conversion between 170, 200, or 240mm frame sizes.

The integrated PDB combines dual shielded voltage regulators, filtered 12V @ 2A and 5V @ 3A outputs, a directly mounted XT60 connector and a low-voltage buzzer. ESC signal pads and dedicated pads aligned with the flight controller support tidy wiring. Three programmable RGB LEDs run on 5V, with control through the flight controller using Cleanflight-Configurator. For recording angled speed runs, the X-Cradle HD camera mount clips and locks onto the included top plate, with screw-adjusted swivel from 30-45 degrees. The motor plates also accept original EMAX Nighthawk Motor Guards.

Propellers & airframes

Specifications

EMAX Nighthawk-X4 specifications
SpecificationValue & conditions
Product code0110001033
Frame geometryPure X frame with equidistant motor placement and centered mass
Motor-to-motor distance170mm
Arm thickness and length3mm thick; available in 4" length
Bottom plate1.5mm carbon fiber
Top plate1.5mm carbon fiber
PDB thickness1.5mm
PDB power outputFiltered 12V @ 2A and 5V @ 3A switching regulators
Voltage regulator shieldingDual shielded voltage regulators
Structural PDBBuilt-in PDB forms the top half of the main structural frame
Battery connectorXT60 connector mounted directly onto the PDB
Low-voltage buzzerIntegrated low-voltage buzzer
Programmable lighting3 programmable RGB LEDsRuns on 5V.
LED controlProgrammable RGB LED colors and featuresThrough the flight controller using Cleanflight-Configurator.
Nighthawk-X4 frame weight85gIncludes all hardware.
Frame size conversion170, 200, or 240mmBy swapping arms.
Motor guard mountingMotor plates accept original EMAX Nighthawk Motor Guards
ESC signal connectionsESC signal pads
Flight controller signal connectionsDedicated signal pads aligned with the flight controller
X-Cradle HD camera mountClip-on, locking HD camera mount with 30-45 degrees of swivel adjustmentClips onto the included top plate; angle adjusted using screws.

Related guides