| Product code | 0107001009 |
|---|
| RF chips | Semtech LR1121 ×2Dual-antenna receiver. |
|---|
| Frequency | 2400–2480 MHz; 900–930 MHz (FCC) / 868 MHz (EU)FCC or EU domain as indicated. |
|---|
| Receive modes | 2.4G diversity, 2.4G Gemini, 915M diversity, 915M Gemini, 915M + 2.4G X-BandDual-antenna receiver. |
|---|
| Required transmitter | Aeris Link Dual TXGemini and X-Band operation. |
|---|
| Serial protocols | CRSF, SBUS |
|---|
| Operating voltage | 5 V |
|---|
| Telemetry power | 10 / 25 / 50 / 100 mW |
|---|
| Antenna connector | IPEX1 |
|---|
| Frequency reference | Built-in TCXO; temperature-compensated crystal oscillator corrects frequency drift |
|---|
| Status LED | RGB LED indicates band, follows packet rate and flags abnormal states |
|---|
| Firmware and settings interface | WiFi web UI for firmware updates and settings changes from a phone or laptop |
|---|
| Dimensions | 20 × 16 × 3 mmDual-antenna receiver. |
|---|
| Weight | 1.35 gDual-antenna receiver. |
|---|
| Packet rates | 2.4 GHz 50–500 Hz including DK250 / DK500, 915 MHz D50–250 Hz including Full-resolution rates, X-Band 100 Hz Full / 150 Hz.With the Aeris Link Dual TX; packet rates follow the ExpressLRS transmitter. |
|---|
| Antennas | 2 × dual-band T antenna (IPEX1)Dual-antenna receiver. |
|---|
| Supplied receiver | Aeris Link Dual Band receiver ×1 |
|---|
| Supplied cable | 4-pin cable, 100 mm ×1 |
|---|
| Supplied heat-shrink | Heat-shrink ×1 |
|---|
| Transmitter supply | Transmitter sold separately |
|---|
| Standard ExpressLRS operation | Standard ExpressLRS receiver operationWith a 2.4 GHz or 915 MHz ExpressLRS transmitter on the corresponding band. |
|---|
| Version and packet-rate requirements | Matching ExpressLRS major version and a packet rate supported by both ends; LR1121 transmitter required for LR1121-only rates such as DK250 / DK500ExpressLRS transmitter and receiver; DK250 / DK500 operation requires an LR1121 transmitter. |
|---|
| Redundancy and range | Adds redundancy and steadier link quality without extra range; range depends on band, packet rate, output power and antennasGemini and X-Band operation. |
|---|
| Wiring | 5 V, GND, receiver TX to FC RX, receiver RX to FC TXConnection to a free flight-controller UART using the included cable. |
|---|
| Suggested builds | 5-inch freestyle, long range, high-RF-noise spotsDual-antenna receiver. |
|---|
| Simultaneous dual-band reception | Same control packet sent on 2.4 GHz and 915 MHz in parallelX-Band mode with the Aeris Link Dual TX. |
|---|
| Diversity operation | Two complete RF paths listen simultaneously and select the stronger signal2.4 GHz true diversity mode. |
|---|
| RF construction | Two LR1121 RF chips, each with its own antenna |
|---|