| Product | Happymodel Mobula6 HDZERO 1S 65mm HD brushless whoop |
|---|
| Dimensions and wheelbase | Frame wheelbase: 65mm; size: 80mm*80mm*50mm |
|---|
| Battery compatibility and connector | Compatible with 1S LiPo or LiHV battery; PH2.0 battery plug1S LiPo or LiHV battery. |
|---|
| Receiver options | SPI ELRS 2.4GHz or SPI FRSKY 2.4GHz |
|---|
| Included frame and canopy | 1 Mobula6 65mm frame with canopy |
|---|
| Included motors | 4 EX0802 KV19000 Unibell brushless motors |
|---|
| Included propeller quantity | 1 propeller set containing 4 clockwise and 4 counterclockwise propellers |
|---|
| Included camera | 1 HDZero Nano Lite Camera |
|---|
| Included video transmitter | 1 HDZero Whoop Lite VTX |
|---|
| Included spare canopy | 1 spare canopy |
|---|
| Included propeller removal tool | 1 propeller removal tool |
|---|
| Included screwdriver | 1 screwdriver |
|---|
| Flight controller and firmware targets | SuperbeeF4 Lite ELRS/FRSKY; SPI ELRS firmware target: CrazybeeF4SX1280; SPI FRSKY firmware target: CrazybeeF4FRExpressLRS or Frsky receiver configuration. |
|---|
| Flight controller processor and sensors | STM32F411CEU6 MCU, 100MHz, 512K FLASH; SPI-connected MPU-6000, ICM20689, ICM42688P or BMI270 sensorGyro sensor varies by flight controller batch. |
|---|
| Flight controller power and integrated functions | Built-in BLHeli_S 4-in-1 ESC rated 5A each, Dshot600 ready; SPI-controlled Betaflight OSD; SPI Frsky/ExpressLRS receiver; 5V 1A BEC; voltage detection1S LiPo or LiHV input, DC 2.8V~4.35V. |
|---|
| Onboard 4-in-1 ESC | EFM8BB21 MCU; 5A continuous, 6A peak for 5 seconds; BLHeliSuite programmable; factory firmware: S_H_50_REV16_8.HEX; default protocols: DSHOT150/DSHOT300/DSHOT6001S LiPo/LiPo HV input at 2.8v~4.35v; peak current duration: 5 seconds. |
|---|
| ExpressLRS receiver | 2.4GHz SPI ExpressLRS; packet rates: 25Hz/50Hz/150Hz/250Hz/500Hz; IPEX antenna plug; telemetry output power: less than 12dBmSPI ExpressLRS receiver version; binding supported with an ELRS V2.0 firmware TX module. |
|---|
| Frsky receiver | 2.4GHz SPI BUS receiver based on CC2500; Frsky D8/D16 compatible; supports non-EU transmitter D8 mode and EU-LBT (Frsky_x_lbt); 8ch or 16ch; failsafe support; range: 100m~200m under the stated conditions; compatible with Futaba S-FHSS and RedpineFrsky SPI receiver version; 100m~200m range with no ground interference and transmitter and receiver 1 m above the ground. |
|---|
| Motor specifications | EX0802 19000KV; 9N12P; stator diameter: 8mm; stator length: 2mm; shaft diameter: Φ1mm; motor dimensions, diameter × length: Φ10.5mm*14.9mm; weight: 1.7g1S LiPo only. |
|---|
| Propeller construction | Two-blade propeller; weight: 0.19g; material: PC; pitch: 1 inch; center hole diameter: 1mm |
|---|
| HDZero Nano Lite camera specifications | Dimensions: 14x16x11 mm; weight: 1.5gram; 0.5 inch CMOS sensor with sensitivity up to 10650 mV/Lux-sec; low-light performance |
|---|
| Camera field of view at 4:3 | - Diagonal: 130°;
- horizontal: 108°;
- vertical: 84°
4:3 aspect ratio. |
|---|
| Camera field of view at 16:9 | - Diagonal: 122°;
- horizontal: 108°;
- vertical: 65°
16:9 aspect ratio. |
|---|
| HDZero Whoop Lite VTX specifications | RF output: 25mW/200mW; SmartAudio support; 25.5×25.5 M2 soft mounting; antenna retention; removable shielding box; dimensions: 32.5×32.5mm, 29x29mm inner; weight: 4.5grams and thickness: 4mm without shielding1S input; weight and thickness without shielding. |
|---|
| Gyro orientation for MPU6000 and ICM sensors | Gyro direction: CW90°; yaw: 0 degreesMPU6000, ICM20689 or ICM42688P gyro-equipped flight controller. |
|---|
| Gyro orientation for BMI270 | Gyro direction: CW0°; yaw: 0 degreesBMI270 gyro-equipped flight controller. |
|---|