ChinaDroneRequest a quote →
Gesai GS AMPX 60A (5-14S) electronic speed controller with silver finned housing and attached wiresGesai GS AMPX 60A (5-14S) electronic speed controller with silver finned housing and attached wires

GS AMPX 60A (5-14S)

The Gesai GS AMPX 60A (5-14S) is a drone electronic speed controller supporting 5~14S lithium batteries and 3.3V/5V PWM input. It combines a 72A current limit with protection against short circuits, motor stalls, voltage extremes, overheating, throttle signal loss and unsuccessful motor startup.

GesaiMotors, ESCs & propellers

Get a free quote

Product overview

The Gesai GS AMPX 60A (5-14S) electronic speed controller provides drone motor control with support for 5~14S lithium batteries. Its AMPX 60A ESC HV model accepts 3.3V/5V PWM input signals and a compatible signal frequency of 50-500HZ. The controller measures 71*31.44*15.8mm and has 14AWG power wire with an 800mm length, plus a 1000 mm signal wire. Its current limit is 72A, and its operating environment temperature range is -20~65°C. Throttle range calibration uses maximum and minimum throttle positions with audible confirmation.

Protection functions address short circuits, motor stalls, battery voltage, temperature, throttle loss and unsuccessful startup. A short circuit shuts down output until a power cycle, while stall recovery requires throttle to return to zero. Motor startup is prevented below 16V or above 64V battery voltage; this protection is disabled during flight. Output falls to 50% at 125°C, shuts down at 140°C and returns to normal below 80°C. Throttle loss exceeding 2 seconds cuts power until the signal returns; failure to start within 10 seconds of a throttle increase also shuts down output.

Motors & ESCs

Specifications

GS AMPX 60A (5-14S) specifications
SpecificationValue & conditions
BrandGS
ModelAMPX 60A ESC HV
Model NumberAMPX 60A (5-14S)
Compatible Signal Frequency50-500HZ
PWM Input Signal Voltage3.3V/5V (compatible)
Power Wire / Wire Length14AWG/800mm
Supported Lithium Cell Count5~14S
Dimensions (L*W*H)71*31.44*15.8mm
Operating Environment Temperature-20~65°C
Current Limit72A
Signal Wire Length1000 mm
Short Circuit ProtectionOutput shuts down automatically; a power cycle is required to restore normal operation.When a short circuit is detected.
Stall ProtectionThrottle must be reset to zero before operation is restored.When motor stall is detected.
Voltage ProtectionPrevents motor start with battery voltage below 16V or above 64V.At motor startup; voltage protection is disabled during flight.
Temperature ProtectionOutput power reduces to 50% at 125°C; shutdown occurs at 140°C; normal operation resumes below 80°C.At 125°C and 140°C; normal operation resumes below 80°C.
Throttle Loss ProtectionPower is cut and restored when the throttle signal returns.When the throttle signal is lost for more than 2 seconds.
Startup ProtectionOutput shuts down if the motor does not start within 10 seconds.Following a throttle increase.
Throttle CalibrationSet throttle to maximum before powering up, then move it to minimum after two beeps. A "DO Mi so" sound confirms successful throttle range setting.With the motor connected before calibration.

Related guides