ChinaDroneRequest a quote →

GS 120A (5-18S)

The Gesai GS 120A (5-18S), designated AMPX 120A ESC, is a drone electronic speed controller for disc motor control. It combines 5-18S lithium battery support, compatible 3.3V/5V PWM input and a 120A current limit with IP67 construction, RPM and error signal outputs, synchronous freewheeling and multiple protection functions.

GesaiMotors, ESCs & propellers

Get a free quote

Product overview

The Gesai GS 120A (5-18S), designated AMPX 120A ESC, is a drone electronic speed controller with a specialized control algorithm for disc motors. It supports 5-18S lithium batteries, accepts compatible 3.3V/5V PWM input signals and has a 120A current limit. Motor startup to full speed takes 0.25 seconds. Synchronous freewheeling improves throttle linearity and driving efficiency while enabling automatic energy recovery during motor deceleration. RPM and error signal output interfaces are included.

The controller measures 98.0 × 50.0 × 27.9mm and uses 10AWG power wire with an 800mm length. Its sealed, fireproof and waterproof construction carries an IP67 rating and incorporates an anti-corrosion housing. Screw hole mounting allows installation without orientation constraints. The operating environment temperature range is -20 to 65°C. Throttle calibration uses maximum throttle at power-on, followed by minimum throttle after two beeps; a “DO Mi SO” tone confirms completion. A one-year warranty is included.

Protection functions cover short circuits, motor stalls, voltage, temperature, throttle loss and failed startup. Short-circuit shutdown requires a power cycle; stall recovery requires throttle reset to zero. Startup is blocked below 16V or above 80V, with voltage protection disabled during flight. Output falls to 50% at 125°C, shuts down at 140°C and resumes below 80°C. Throttle loss exceeding 2 seconds cuts power until the signal returns. Failure to start within 10 seconds of throttle increase shuts down output and requires throttle reset.

Motors & ESCs

Specifications

GS 120A (5-18S) specifications
SpecificationValue & conditions
BrandGS
ModelAMPX 120A ESC
Model Number120A (5-18S)
PWM Input Signal Voltage3.3V/5V (compatible)
Power Wire / Wire Length10AWG/800mm
Supported Lithium Cell Count5-18S
Dimensions (L*W*H)98.0*50.0*27.9mm
Operating Environment Temperature-20-65°C
Current Limit120A
Response Time0.25 secondsFrom motor start to full speed operation.
Motor Control AlgorithmSpecialized control algorithm for disc motors
Freewheeling TechnologySynchronous freewheeling improves throttle linearity and driving efficiency, with automatic energy recoveryAutomatic energy recovery during motor deceleration.
Included Signal InterfacesRPM and error signal output interfaces
Housing and Waterproof RatingIP67; sealed, fireproof and waterproof construction with anti-corrosion housing
MountingScrew hole mounting with no orientation constraints
Short Circuit ProtectionAutomatically shuts down output; requires a power cycle to restore operationWhen a short circuit is detected.
Stall ProtectionDetects motor stalls; throttle must be reset to zero before normal operation resumesWhen a motor stall is detected.
Voltage ProtectionPrevents motor start if battery voltage is below 16V or above 80VMotor startup; protection is disabled during flight.
Temperature ProtectionReduces output power to 50% at 125°C and shuts down at 140°C. Normal operation resumes below 80°COutput reduction at 125°C; shutdown at 140°C; recovery below 80°C.
Throttle Loss ProtectionCuts power and restores power when the signal returnsThrottle signal lost for more than 2 seconds.
Startup ProtectionShuts down output; requires throttle resetMotor does not start within 10 seconds of throttle increase.
Throttle CalibrationConnect motor, set throttle to maximum and power on. After two beeps, set throttle to minimum. A "DO Mi SO" tone indicates successful calibrationMotor connected; maximum throttle before powering on, then minimum throttle after two beeps.
Included Warranty1 Year Warranty

Related guides