Product overview
The BETAFPV Meteor75 Brushless Whoop Quadcopter (2022) is a 1S FPV aircraft for indoor flying and outdoor use around a house or yard. Its 75mm Meteor75 frame carries 0802SE 19500KV brushless motors and 40mm two-blade propellers with 1.0mm shafts. The listed aircraft weight is 24.98g, while the frame itself weighs 5.68g. Its battery slot sits closer to the center of gravity, and the motor screws provide landing contact beneath the aircraft. An injection-molded, 1.60g micro canopy covers the camera installation.
The analog imaging system combines a C03 FPV camera with an M03 25-350mW video transmitter. The 1.45g camera has a 1200TVL specification, a 1/3-inch CMOS sensor and a 2.1mm lens providing a 160° field of view; camera tilt is 30° by default or 20° optionally. Receiver choices are ELRS2.4G, Frsky/PNP and TBS Crossfire. Integration capacity depends on configuration: the serial ELRS controller has one UART and does not support an external receiver, while the SPI Frsky controller has two UARTs and supports external receiver installation.
The supplied configuration includes the aircraft, two BT2.0 450mAh 1S 30C batteries, a charger and voltage tester, a TypeC USB cable, a carry case and spare hardware. Flight time is 6 minutes for stable flying or 4.5 minutes for acro flying. Controller maintenance requires attention to firmware selection: serial ELRS needs Betaflight 4.3.0 or later for BMI270 support, with the Meteor75 CLI dump required when updating from the official Betaflight distribution. The SPI Frsky configuration has a separate recommendation for BETAFPVF411RX 4.2.11 and its associated CLI dump.
Specifications
| Specification | Value & conditions |
|---|---|
| Product | BETAFPV Meteor75 Brushless Whoop Quadcopter (2022) |
| Platform and intended use | 1S brushless whoop quadcopter for indoor and outdoor FPV flying. |
| Flight controller and ESC | F4 1S 5A FC (Serial ELRS 2.4G) / F4 1S 5A FC (SPI Frsky) |
| Frame | Meteor75 Frame |
| Frame size | 75mm |
| Frame weight and battery placement | 5.68g frame; battery slot positioned closer to the center of gravity, with landing contact on the motor screws rather than the battery. |
| Motors | 0802SE 19500KV brushless 1S motors; 1.88g/pc. |
| Propellers | 40mm 2-Blade Propellers (1.0mm Shaft) |
| Camera | C03 FPV Camera |
| Camera imaging specifications | 1.45g; 1200TVL; 1/3-inch CMOS sensor; 2.1mm lens; 160° FOV. |
| Camera tilt | 30° (default)/20° (optional)30° default; 20° optional. |
| Canopy | Canopy for Micro Camera 2022 version |
| Canopy construction and weight | Injection-molded canopy; 1.60g. |
| Receiver options | ELRS2.4G, Frsky/PNP, TBS Crossfire |
| Video transmitter | M03 analog VTX; 25-350mW. |
| Battery | BT2.0 450mAh 1S 30C Battery |
| Flight time | 6 mins (stable flying) / 4.5 mins (acro flying)6 mins during stable flying; 4.5 mins during acro flying. |
| Weight | 24.98g |
| ESC hardware and firmware | BB51 hardware with Bluejay 96k ESC firmware. |
| ELRS controller integration | BMI270 gyro; BETAFPVF411 firmware target; one UART port; external receiver not supported.ELRS configuration. |
| Frsky-based controller integration | BMI270 gyro; BETAFPVF411RX firmware target; two UART ports; external receiver supported.Frsky, PNP and TBS configurations. |
| Alternative receiver protocol | Can operate as PNP with an external receiver and can switch to Futaba SFHSS through Betaflight configurator.Frsky version. |
| Independent receiver firmware upgrade | Supports upgrading to ELRS V3.0 separately without flashing Betaflight flight controller firmware.F4 1S 5A FC (Serial ELRS 2.4G). |
| ELRS Betaflight requirement | Betaflight 4.3.0 and up required for BMI270 gyro support.F4 1S 5A FC (serial ELRS 2.4G); BMI270 gyro support. |
| Frsky firmware recommendation | BETAFPVF411RX 4.2.11 firmware with the BETAFPV CLI dump file recommended.F4 1S 5A FC (SPI Frsky). |
| Firmware configuration requirement | Flash the Meteor75 CLI dump file after the firmware update.Updating serial ELRS 2.4G to Betaflight 4.3.0 and up from the official Betaflight distribution. |
| Aircraft, batteries and charging equipment | 1 Meteor75 Brushless Whoop Quadcopter (1S); 2 BT2.0 450mAh 1S 30C batteries; 1 BT2.0 Battery Charger and Voltage Tester; 1 TypeC USB cable.Supplied package. |
| Case, spares and assembly accessories | 1 customized carry case; 1 spare 40mm two-blade propeller set for 1.0mm shafts; 1 screwdriver; 3 decorative parts; 1 20° C03 camera mount; 1 30° C02 camera mount; 1 pack of screws.Supplied package. |
| Replacement frame and canopy | Meteor75 Micro Brushless Whoop Frame; Canopy for Micro Camera 2022.Recommended parts; separate from the supplied package. |
| Accessory charger and motor screws | 6 Ports 1S Battery Charger & Adapter; Meteor Series Motor Fixing Screws Pack (40PCS).Recommended parts; separate from the supplied package. |
Ask for the BETAFPV Meteor75 Brushless Whoop Quadcopter (2022) price ↑