ChinaDroneRequest a quote →

Autel EVO Max 4T vs DJI Matrice 4T | Thermal Inspection Procurement Guide

Updated · 9 min read

Compare thermal files, visible cameras, aircraft kits and revision-specific spares for repeatable building and solar inspections.

For a roof inspection, the buying decision often comes down to two files. Can the analyst measure a warm patch in the thermal original, and can the roofer find the same patch in a visible photograph? Both the Autel EVO Max 4T and the DJI Matrice 4T can collect those views. Start with Autel if an inspector needs to adjust optical framing continuously. Start with DJI if crews want repeatable views at three documented focal lengths or carry their aircraft between sites on foot.

Compare the inspection kits

Autel EVO Max 4T vs DJI Matrice 4T procurement comparisonAircraft weights refer to the configurations shown. Flight times are manufacturer test maxima.
PartWhat to look forMatching products
Aircraft massOriginal 4T with ABX40, gimbal and propellers: 1,645 g. Matrice 4T with standard propellers: 1,219 g.
EnduranceAutel publishes up to 42 minutes. DJI publishes up to 49 minutes with standard propellers.
Wide viewFusion 4T: 50 MP, 1/1.28-inch sensor and a 23 mm-equivalent f/1.9 lens. Matrice 4T: 48 MP, 1/1.3-inch sensor and a 24 mm-equivalent f/1.7 lens.
Detail viewsAutel offers 10x continuous optical zoom. DJI provides 70 and 168 mm equivalent cameras alongside its 24 mm wide camera.
Thermal outputBoth use a native 640 by 512 thermal image. Autel documents video at 25 fps for Fusion 4T. DJI lists 30 fps and offers 1280 by 1024 video with Super Resolution enabled and Night Mode off.
Battery energyAutel ABX40: 120 Wh. Autel ABX41: 136.5 Wh. DJI Matrice 4 Series: 99.5 Wh.
WeatherAutel lists IP43 as a custom service. DJI advises avoiding contact with water.
SensingAutel combines vision and radar. DJI specifies binocular vision and a downward 3D infrared sensor.
Laser rangefinderAutel lists 5 to 1,200 m, with accuracy specified for distance to a vertical reflecting plane. DJI lists up to 1,800 m at 1 Hz on a 20% reflectivity target, with a separate oblique-incidence figure.
Payload interfacesAutel documents P-Port and P-Port Lite for the EVO Max series. DJI documents E-Port and E-Port Lite for Matrice 4T, with device support varying by port.
Live video systemAutel uses SkyLink 3.0. DJI uses O4 Enterprise. Confirm the regional radio configuration and assess the live image at the intended sites.
Maximum takeoff weightAutel lists 1,999 g for the EVO Max family. DJI lists 1,420 g with standard propellers and 1,430 g with low-noise propellers.

Send this list as it is and get one price for every part.

Quote the full parts list →

The Autel figures here refer to the original aircraft with the Fusion 4T gimbal. Its name appears alongside the XE and V2 in family literature. Those suffixes identify different configurations. Have the supplier put the aircraft, gimbal and battery model on the same line of the equipment schedule. On the DJI side, specify Matrice 4T in full. The similar-looking 4E has a different camera package, an expensive detail to discover when the first thermal inspection is due.

Match the cameras to the report

On a solar site, evaluators can give each crew the same short assignment. Photograph a row of panels, identify a module with a known anomaly and deliver the paired thermal and visible originals. Ask an analyst who was absent from the flight to identify the module from those files and annotate it for maintenance. This checks a feature that a camera chart cannot capture easily. A close view has limited value once its position in a long row becomes ambiguous.

For facade surveys, the original Autel zoom camera lets an inspector tighten the frame around a joint while keeping a useful amount of adjacent brickwork in view. DJI's 24, 70 and 168 mm equivalents give a survey designer three convenient reference views. A crew returning next season can follow a shot list built around those views. Have the editor check a printed report page from each kit. Fine lines that look distinct on the controller may merge once the page is resized.

Both aircraft start with a 640 by 512 thermal image. DJI also offers a super-resolution recording mode under specified conditions. A client requiring a native detector resolution should see that figure listed separately from the delivered image dimensions. Ask for a thermal original from the gain mode used on site, open it in the intended analysis application and save a report with the measurement location visible. The ability to reopen the original months later matters when a client disputes a reading.

For quantitative work, use a reference surface with a known temperature and record its material, viewing angle and measurement conditions. Shiny cladding and a matte reference patch can produce different apparent temperatures on the same roof. Agree with the client on what constitutes a finding and when a technician must verify it on site. DJI publishes different accuracy limits for high and low gain. Apply the limit for the selected mode when deciding whether a small difference merits further investigation.

Plan for a full shift

DJI has the lower published takeoff weight and the longer published maximum flight time in this comparison. For a walking crew, weigh the packed case as well. Include the controller, charger, required spare batteries, reference equipment and the device that holds the inspection records. A lighter aircraft can still require a second case. For vehicle-based work, measure the time from opening the case to filing a complete pair of images for the first asset.

Need a quote for this? Tell us what you need →

Treat the two flight-time figures as ceilings from manufacturer tests. A useful shift estimate starts with minutes spent collecting acceptable images before the crew's normal landing reserve. Include time for setup, an interrupted inspection, file checks and battery changes. Run the test with the specified propellers and accessories. DJI lists 49 minutes with standard propellers under its test conditions. A kit ordered with low-noise propellers has a different endurance specification, even though the cameras are identical.

A weather requirement can decide the purchase before either aircraft flies. Autel describes IP43 as a custom service. Ask for documentation covering the delivered configuration if the tender requires that rating. DJI advises operators to avoid water and to land if rain starts. For an outdoor maintenance contract, agree on how unfinished lines of a survey will be identified and picked up after a weather interruption. This gives the client a realistic completion record across several visits.

Controllers, batteries and spares

DJI specifies the RC Plus 2 Enterprise and Pilot 2 workflow. Its AL1 spotlight and AS1 speaker are separate accessories. Decide which crews actually need either item before duplicating the accessory order across every aircraft. Matrice 4T batteries require a Matrice 4 Series Charging Hub. Autel lists optional RTK and speaker/spotlight accessories for the EVO Max family. For either aircraft, ask the integrator to name the supported payload, mounting hardware, port and firmware. Include pairing and access to stored work in the handover trial. Have a second operator locate yesterday's survey, export the required files and prepare the kit for a new job using the account permissions staff will have in service.

For Autel, record the Smart Controller version and ask for the charger and battery identifiers supplied with the aircraft. The ABX40 and ABX41 have different rated energy. A case built around one pack description can reach a traveling crew with a different battery from the one on its equipment paperwork. Use the label on the delivered pack for transport planning. Keep a record of battery identity, condition and use so the team can investigate a gradual change in working time.

Autel's manual identifies the 4T Pro as discontinued and specifies 1158 as the replacement for discontinued 1136 propellers. Autel's product page now leads with the 4T V2, whose wide camera, thermal lens and standard battery differ from the original configuration. DJI introduced Matrice 5T as its newest compact enterprise flagship on November 5, 2026 and continues to publish Matrice 4T support material. The manufacturers' reviewed materials give no formal end-of-sale date for either aircraft in this comparison. For repeat orders, request written confirmation of the exact version offered, the service arrangement in the destination market and the procedure for approving a proposed substitution.

Write the acceptance terms

Give the supplier one representative report page and the list of originals the analyst needs to recreate it. Specify whether the client expects temperature readings, contextual stills, filenames traceable to an asset or a particular export format. Keep one accepted sample with the purchasing record. If a replacement gimbal arrives later, the service team will have a practical reference for checking that its output still fits the client's archive.

Inspect a sample kit before accepting a fleet batch. Match the labels to the order, verify both imaging channels, check the charger with the supplied packs and confirm the spare propellers match the documented replacement. Record the firmware versions alongside the sample files. Then repeat the file handover with the operator disconnected from any office resources that will be unavailable on site. This last step often reveals whether a crew can finish the day's paperwork from its field case.

When a tender covers more than one depot, have each depot identify where it will charge packs and archive thermal originals. A shared aircraft is easier to schedule when the next crew can tell which batteries are ready and which survey files have already reached the analyst.

For an inquiry, send our team the inspection type, destination, existing controller and battery inventory, typical walking distance and an example of the report your client accepts. Include the number of crews working at the same time. Those details determine how many complete kits, chargers and sets of spares need to be considered alongside the aircraft themselves.

Frequently asked questions

Which kit is lighter for walking surveys?

The Matrice 4T has the lower aircraft weight. Weigh the complete field cases with the number of packs your crew actually carries.

Does DJI super resolution meet a native 1280 by 1024 requirement?

Its native thermal resolution is 640 by 512. Ask the client whether processed output is acceptable before specifying the higher recording mode.

Can we request an IP43 Autel by model name alone?

Specify the customization and request confirmation for the delivered unit. Autel qualifies the rating on its product page.

Which Autel propeller should a legacy spare list name?

Autel identifies 1158 as the replacement for discontinued 1136 propellers. Match the order to the aircraft documentation.

Has the original 4T been discontinued?

Autel's manual explicitly marks the 4T Pro discontinued. The original Fusion 4T configuration is listed separately. Confirm its orderability for your destination.